Page 176 - byob-catalog

174
ELECTRICAL
AC Digital Multimeter with Alarm
Guest Charge ProTM Battery Chargers
Waterproof Battery Chargers
Waterproof
Pro Sport Gen 3
2711A
2720A
2731A
43012
mfr
MAR FIG 9762
These charges are low profile and have a flangeless extruded alumi- num housing sealed by gaskets with heavy duty end caps for 100% waterproof performance to IP67. They are fully automatic and have 5 stage performance charging. They have reverse polarity, over cur- rent, over voltage and over temperature protection. LED lights show charging status. They are pre-wired for easy installation and have in-line fuses for maximum DC wire protection. Ignition protected. For flooded and AGM lead acid batteries.
2711A is for two 12- or one 24V system. Supplies 10 Amps in two 5 Amps circuits for independent charging. Includes two 6-ft. DC out- put cables and one 6-ft. AC input cord. Size: 7.5"W x 2.4"H x 9.0"L. Weight: 4.7 lbs.
2720A is for two 12- or one 24V system. Supplies 20 Amps in two 10 Amp circuits for independent charging. Includes two 6-ft. DC out- put cables and one 6-ft. AC input cord. Size: 7.5"W x 2.4"H x 12.9"L. Weight: 6.6 lbs.
2731A is for three 12- or one 24V and one 12V or one 36V system. Includes three 6-ft. DC output cables and one 6-ft. AC input cord. Size: 9.0"W x 4.1"H x 8.7"L. Weight: 8.0 lbs.
mfr
P/M
43020
Part No. Each
2711A $215.22 2720A $258.25 2731A $468.48 2701A $50.95
Output Total Input
12 2 20 2 20 3
43012, 43020 and 43021 fully-automatic chargers maintain your engine crank battery while sensing and distributing up to 20 Amps to your trolling motor battery for faster charging, and conditions your batteries with a built-in safe maintenance mode for long or short term storage. They have 3 user selectable performance charge profiles for: Flooded (Lead/Acid)/STD, AGM, GEL and high performance AGM batteries. The LED status center provides at-a- glance status of: AC power, charge mode, battery type, and ready/ maintenance mode. They are 100% waterproof and shockproof, have dual inline DC safety fuses for trolling motor battery banks, dynamic thermal output control, over voltage, overload, over tem- perature, reverse polarity, and ignition protection.
Part No.
44012 44020 44021
Each
$228.86 $270.73 $286.52
Volts
12/24 DC
12/24 DC 12/24/36 DC
Amps
Banks
Weight
9 lbs. 10 lbs. 11 lbs.
43021
Volts
12/24
12/24 12/24/36 12
Amps Volts
10 90-135V AC 20 90-135V AC 30 90-135V AC 1.5 120V AC
Bat Savr
Cycle
Banks
50-60 Hz 2 50-60 Hz 2 50-60 Hz 3
1
DC Digital Multimeter with Alarm
mfr
BSS
16-Watt Fully Automatic Battery Charger/Maintainer
mfr
P/M
Designed for charging up to 25 Amp hours per day as well as long term battery storage. Will charge and maintain 12V batteries (10-250 Amp hours) for prolonged periods without boiling out battery electrolyte. Prolongs battery life significantly. Will not overcharge or damage batteries if left con-
nected for extended periods. Just plug it into a standard 120V AC outlet and connect alligator clips to your battery. It is fully automatic and has reverse polarity protection. Features precise voltage regulation and an LED light signifies proper operation. Is current limiting and has over temperature protection. Field adjustable for gel batteries.
This gauge displays amperage from 0.1 Amp to 99.9 Amps and to 1 Amp from 100- 500 Amps, positive and negative. Displays voltage to 0.01 Volt from 7 to 60 Volts (12, 24, 32, 36 and 42 Volt systems). Has a set- table high and low voltage audio and visu-
al alarms, 3 display brightness levels and a 500-Amp shunt. Mounts in a 2" diameter hole.
Part No.
8248
Each
$373.99
Part No. Each Input Volts
Input Cycle
50/60 Hz
44001
mfr
VIC
$48.07 117 (+/-) 20% AC
Skylla-i Battery Chargers
24 VDC
mfr
BSS
This gauge displays amperage from 1 Amp to 150 Amps in 1 Amp increments, voltage from 70 to 300 Volts in 1-Volt increments and Watts to 9999 in 1-Watt increments. Also displays frequency from 40 to 90 Hz in 1 Hz increments. Has a settable high amp audio
Variable absorption time. Battery Safe mode prevents damage due to excessive gassing. Storage mode for less maintenance and aging when the battery is not in use. NMEA2000 Canbus connection. Li-ion (LiFePo4) ready.
Part No. Each Description
and visual alarm and 3 display brightness levels. Includes current transformer. Mounts in a 2" diameter hole.
Part No. Each
8247 $411.99
SKI024100000 $1,675.00 24 VDC, 100 Amp, 1+1 Outputs
BATTERY CHARGERS/INVERTERS/SOLENOIDS