Page 268 - byob-catalog

266
PUMPS
Part No.
52530-1000
Water Circulating Pump
Each
S/O Only
* WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Raw Water Pump
for PCM/Crusader 50470-1101
mfr
JAB
Raw water pump for PCM®/ Crusader® (Serpentine Belt Driven)
Double Stack Water System
mfr
JAB
Double Stack Water System - 9.0 GPM - 40PSI - 12V Double stack water systems are high flow (9 GPM, 34 LPM) for up to 7 outlets. Combines two pumps assembled onto a pre-pressurized accumulator tank to smooth flow and prevent pump cycling. Self-priming up to 6-10' (2-3M). Features: Run-dry ability Smooth, even flow Two stage operation Internal bladder accumulator tank Thermal overload protec- tion Complies with ISO 8846 MARINE (Ignition Protection) Three-year warranty Specifications: Flow: 9 GPM (34 LPM) Voltage: 12V Shut-Off Pressure: 40 PSI (2.8 bar) Fitting: Connections for 3/4" (19mm) hose tail Size: 13.6" Long x 12.2" Wide x 13.6" High Weight: 21lb (9.58kg).
mfr
JAB
This Jabsco flange mounted engine driven water pump has been used on a wide range of engines includ- ing Commander Marine, Glastron and more.
Engineered for marine applications
and a long service life, the body is
cast bronze and features a stainless
steel shaft. Impeller access is available by removing the front por- tion of the pump body. Hose barbs are cast into the pump body so that tail pieces are not required for installation.
Part No. Each
18830-1020 $450.02
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Engines.
Part No.
50470-1101
Each
S/O Only
mfr
JAB
FIG 3308
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Water System Pumps Par-Max 1
These self-priming water system pumps are for small cruisers and runabouts. Can be mounted above or below tank. The motor can run dry without damage. They have fixed ports for 3/8" hose and are over- load-protected. These pumps are available as automatic and manual demand pumps. The 42630-2900 will automatically turn on when a fixture is opened and turn off when all fixtures are closed. The 42631-2900 is a manual demand pump for use with an electric faucet. When starting up an automatic demand pump with a completely dry system, allow time for the demand pump to fill the sytem. Open a faucet, allow air to vent and close faucet when water flow is steady.
Part No.
42630-3512-3C
Freshwater Pump
Each Volt Amps Cut-In
$85.59 12 DC 1.9 22 PSI
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
FIG 9916
Cut-Out GPM
35 PSI 1
mfr
WWS
This pump mounts in any existing installation. It has a smooth constant flow and runs dry. Set up for 15mm female connections INCLUDES: two 1/2" BSP male adaptors and two 1/2" flexible hose adaptors. Will run four outlets and self-primes to 10 feet. Inlet strainer INCLUDED.
Part No. Each Volts Amps GPM Cut-Out Weight
UF1215 $228.00 12 8 3.2 45 PSI 5.3 lbs.
WATER SYSTEM PUMPS